If you want to move the i-effect installation from the *SYSBAS to an IASP, or from an IASP to the *SYSBAS, the following script can be used to make the necessary changes to the configuration.
Preparation
i-effect must be terminated for this action with
IEFFECT/ENDEFFSBS *ALL
During the action, the i-effect subsystems may not be started automatically. This can be prevented by setting the following environment variable
ADDENVVAR ENVVAR(IEFFECT_AUTOSTARTSBS) VALUE(*NO) LEVEL(*SYS)
Move i-effect to an IASP
Enter the following command in a terminal to move the existing installation from *SYSBAS to an IASP named "IASP34
QSH <enter>
/i-effect/v2r8m0/base/tools/scripts/setup.sh --mode move --targetdevice iasp34
This procedure can be used to move i-effect to an IASP under IBM i 7.2, since a direct installation into the IASP is not supported in this operating system version.
Please note that such an installation must be moved back into the *SYSBAS as described below BEFORE installing another update/upgrade.
Move i-effect from an IASP to the *SYSBAS
Enter the following command in a terminal to move the existing installation from the IASP named "IASP34" to the *SYSBAS
QSH <enter>
/i-effect/v2r8m0/base/tools/scripts/setup.sh --mode move --targetdevice *sysbas