Skip to main content
Skip table of contents

Update of i-effect *SIGG

In order to install a new version of i-effect *SIGG, the older version must be uninstalled before.
i-effect *SIGG can be uninstalled either from the Control Panel-> Software or from the Windows menu:

After uninstalling is successfully completed, the new version of i-effect *SIGG can be installed as is described under "i-effect*SIGG installation."

If an update of i-effect - the integrated solution for IBM Power Systems - is desired, it is required that the version of i-effect *SIGG also be updated to the correct version!

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.