Skip to main content
Skip table of contents

Installation of the card reader

The card reader CHIPDRIVE pinpad 532 from SCM Microsystems, which is in accordance with German signature law, is used.

Driver Installation

IMPORTANT!
The driver must be installed and the system restarted before the card reader is attached!

The current driver version of the card reader will be on the installation volume. Start the installation by running "Setup.exe" and follow the installation instructions.
It is recommended that the option for manual restart is used.
Afterwards, the user will be asked to connect the card reader for a firmware update. This is normally not required, and possibly not desired, because for the generation of qualified digital signatures the Federal Network Agency only allows firmware version 4.15 or 5.10 for this type of card reader.

Note:
A version downgrade can only occur by returning the device to the manufacturer.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.