Skip to main content
Skip table of contents

Special Report Parameters/JasperReports Parameters

Via the following RUNREPORT parameter, Build-In Parameter from Jasper Reports (short term: JR) can be controlled respectively sedated.


This RUNREPORT parameter controls the correspondent JR parameter "REPORT-LOCALE". Here you enter "REPORT-LOCALE" as parameter name and one of the following ISO Locale Code as parameter value in RUNREPORT:
The locale inside the report generation is set according to the ISO Code.
Example for setting of English Locale:

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.