i-effect uses the exit points QIBM_QCA_CHG_COMMAND and QIBM_QCA_RTV_COMMAND.
If it is necessary to recreate these i-effect exit points, the following command can be used. In the command, replace vXrYmZ with the installed version, e.g., V3R1M0Exitpoints erstellen
Create Exit Points
Enter the following command in a QSHell (STRQSH) or SSH session:
/home/ieffect/current/base/tools/scripts/setup.sh --mode recreateexitpoints --version vXrYmZ
Messages
The following messages are displayed on the console
qsecofr@MAPRM:~# /home/ieffect/current/base/tools/scripts/setup.sh --mode recreateexitpoints --version v3r1m0
*** (setup.sh) Started at: Wed Sep 16 09:01:36 CEST 2026
Remove old command exit point entries...
Configure objects..
Adjusting commands...
*** i-effect Mode:RECREATEEXITPOINTS operation completed.
SETUP finished successfully
*** (setup.sh) Ended at: Wed Sep 16 09:04:08 CEST 2026 <2 minutes and 34 seconds>
qsecofr@MAPRM:~#